There are four shunts on the board. They are defined below.

Shunt State Description
J10 In Allows software control of the V_LCD Enable
J10 Out V_LCD is forced on
J11 In V_LCD = 3.3v
J11 Out V_LCD = 5v
J14 In 8 bit LVDS data
J14 Out 6 bit LVDS data
J2 N/A GND - Test point

Contact Us

We don’t believe in the run-around. If you have any questions about our products or services, you can speak directly with our engineering team. You can get your answer right from the source.

Speak With An Engineer

Totally free and no obligation.